Step 1
Take out the camera, screw accessories, and carabiner accessories from the packaging box.
Step 2
Remove the magnetic nameplate on the top of the laser cutting machine.Step 3
Use the screw fittings to secure the camera to the top of the laser cutter.
Note: Please remove the black protective cover on the camera after fixing it.
Step 4
Organize and secure your camera's wiring with the carabiner accessory.Step 5
Connect the camera's USB cable to your computer, open LightBurn, and follow the instructions below to complete the connection. You can start using it normally.
Note: Each time before using the camera, you need to perform a device connection and a two-step (Camera lens calibration and Camera alignment calibration) camera calibration operation.